Showing posts with label emergency. Show all posts
Showing posts with label emergency. Show all posts
Wednesday, November 20, 2013
Automatic Emergency Lamp Circuit
This is an automatic emergency lamp with day light sensing, means it senses darkness/night and turns ON automatically. Similarly it senses day light and turns OFF automatically. A simple emergency lamp which does not require any special equipment; even a multimeter to assemble and use. Any individual who can do a good quality soldering must be able to build this circuit successfully.
This can be easily accommodated in the defunct two 6 watt tube National Emergency Lamp or any PL tube type emergency lamp. The difference will be in the working; it will work non stop for more than 8 hours. Deep discharge is taken care by the LED characteristic and over charge protection is taken care by the fixed voltage regulator.This uses a simple 3Pin fixed regulator which has a built in current limiting circuit.
Simple Emergency Light Circuit Diagram:
 |
| Automatic Emergency Lamp Circuit |
The only required adjustment is the preset which has to be set to ensure the LEDs just light up (it should be left at that position). The 5mm LDR is just mounted on top of the emergency light as shown in the photograph. LDR is used to avoid it lighting up during day time or when the room lights are ON. 2 LEDs are used in series; the dropping resistance is avoided and 2 LEDs light up with current that is required for a single LED, by which energy is saved to a great extent.
This particular circuit has been kept so simple for people who has limited access to components or in other words this is an emergency light that you can build with minimum components. In addition to circuit diagram, He has shared photographs of the prototype he made in National emergency light and a PCB design.
Friday, October 25, 2013
Emergency Light Flashlight
3 in 1 - LED Night Light, LED Emergency Light and LED Flashlight; Length: 4.0". The Night Light has an Automatic Sensor which allows On at Dusk and Off at Dawn. The Emergency Light features an 8 Hour Battery Back Up. Convenient White Light Flashlight.
When its used having the status of a nightlight it is a not much dimmer but still upbeat adequate to perceive your way around.
The light stays on a bunch longer than the circular emergency plug concerning illumination with the aim of Ive used in the older and it looks a lot better than them. I carry out think it would look even better devoid of the flashlight part of the light and I would have a preference to grasp a version like with the aim of if theyd offer it.
Once plugging into a lookalike outlet it still leaves area intended for a lesser plug to progress into the outlet then to it.
Thursday, October 3, 2013
Emergency Lamp using IC 555
Emergency Lamp With 555 is one solution for lighting during power outages. With Emergency Lamp Series 555 uses a 12VDC voltage source that can be supplied from the 12V battery. Emergency Lamp 555 Series With these very simple and easy to make because all the components easily available in the market.
Emergency Lamp Series With this 555 can turn on the light 5W-10W. The circuit is built with an astable multivibrator with the IC 555 that is used to mendrive transformer through Q1. For more details can be viewed directly from the series Emergency Lamp With 555 follows.
 |
| Emergency Lamp Using TLC555 |
Working frequency range of 555 Emergency Lamp With this set of configurations R1, R2 and C2. T1 in series Emergency Lamp With 10V 500mA 555 is a transformer. Secondary part (0-10V) is connected to the Q1 to be given the signal from the multivibrator. Then the primary (0-220V) is connected to the lamp.
Subscribe to:
Posts (Atom)