Circuit Wiring

7.1 Surround Sound Systems

7.1 channel audio systems is the modified version of 6.1 channel and plus provide additional realistic experience than 6.1 setup. at home this organization splits the single rear-hub amp into private not here- and moral-rear surround. These systems are not a stanch discrete 7.1 channel system to the same degree 7.1 formats don’t at this time exist. In a true discrete 6.1 surround method, the back center surround attitude is separate from the surround not here (SL) and surround right (SR) positions. A 7.1 channel system uses   matrixes extended surround wherever the not here-back and right-back (rear-inside surround) multichannel are blended at once and stored. The assembly of a 7.1 setup is agreed voguish the Picture under.

3 channel audio mixer is built using some of the transistor amplifier.
3 channel audio mixer circuit uses voltage 9VDC summber which can supplied from a battery. 3 channel audio mixer circuit is designed special for the purposes of this Public Amplifier.



Because the audio circuit of this mixer is designed specifically for the purpose of a portable mixer for audio public then this series has only a volume control without the tone control. Image series that looks below audio mixer is a series of mono, if you want to make a 3 channel stereo audio mixer it is necessary to make 2 pieces of a series of three channel audio mixer terebut. For more details, a series of three channel audio mixer can be seen in the following image.

In a series of three channel audio mixer is equipped with a switch on each chanelnya which select the input impedance, when the switch SW1, SW2 and SW3 in the open then the input should come from the output signal with a high level such as VCD, MP3 player, tape, computer and tuner . And at SW1, SW2 and SW3 closed position, the input should come from a weak audio signals such as microphones.

A very simple 6 channel low cost led driver electronic circuit project can be designed using the MCP34845 LED drivers manufactured by Free scale Semiconductor.The MCP34845 LED drivers operates from 5 to 21 volts and is specially designed for use in back lighting LCD displays from 10" to 17"+ for devices like : PC Notebooks , Net books , Picture Frames , Portable DVD Players , Small Screen Televisions , Industrial Displays , Medical Displays , etc.

6 Channel LED Driver Circuit Diagram



The MCP34845 LED drivers is capable of driving up to 16 LEDs in series in 6 separate strings.PWM dimming is performed by applying a PWM input signal to the PWM pin which modulates the LED channels directly.Main features of this driver circuit project are : input voltage of 5.0 to 21 V , boost output voltage up to 60 V, 2.0 A integrated boost FET , fixed boost frequency - 600 kHz or 1.2 MHz , OTP, OCP, UVLO fault detection , LED short/open protection , programmable LED current between 3.0 mA and 30 mA .

This Car Audio Amplifier to run an older 8 inch pioneer sub in a bandpass box . This delivers as expected. Subwoofer sounds perfect. I tried to run it off the stock deck using the high pass but it wouldnt turn on. I took a jumper wire and touched the remote to the positive and it fired up immediately. Dont expect any help from Boss via their phone number on the box. I waited for 20 minutes before I just decided to hang up and just pick up a new deck. It sounds great.

That this amp would not do a good job pushing a subwoofer is that it only has a "Subwoofer level control". This is not to be mistaken for a crossover/low pass filter. You need some form of crossover to keep it from sending high frequencies to the speaker.